Capresso Cafe 115 Service Manual download pdf (Page 43)

43

7 Troubleshooting

7 Troubleshooting

Problem Cause/Result Action

When preparing a latte

macchiato, the typical

three layers do not

form.

–

T Turn the setting wheel of the cappuc-

cino to the far right and the Milk Foam

position ü.

T Change the length of the interval to at

least 30 seconds in programming mode

(see Chapter 4 ‘Permanent settings in

programming mode – Product settings’).

Insufficient foam is

produced when the milk

is frothed or milk sprays

from the cappuccino

frother.

The cappuccino frother is

dirty.

T Rinse and clean the cappuccino frother

(see Chapter 5 ‘Maintenance – Rinsing

the cappuccino frother’).

T Check that the air intake pipe is fitted

on the cappuccino frother.

T Rinse or replace the air intake pipe. You

will find a replacement in the Welcome

Pack.

Coffee only comes out

in drips when it is being

prepared.

Coffee or ground coffee

has been ground too

finely and is blocking the

system. The same filter

cartridge may have been

used several times or the

water hardness set

incorrectly in the pro-

gramming mode.

T Put the grinder on a coarser setting or

use coarser ground coffee (see Chapter 1

‘Preparing and using for the first time –

Adjusting the grinder’).

T Perform descaling (see Chapter 5

‘Maintenance – Descaling the machine ’).

Water hardness cannot

be adjusted.

The CLEARYL Blue filter

cartridge is activated.

T Deactivate the filter cartridge in

programming mode.

‘Fill bean container’

is not displayed

although the bean

container is empty.

The bean monitor is dirty.

T Clean the bean container (see Chapter 5

‘Maintenance – Cleaning the bean

container’).

‘Empty drip tray’

is always displayed.

The metal contacts of the

drip tray are dirty or wet.

T Clean and dry the metal contacts on

the back of the drip tray.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Comments to this Manuals

No comments